Bandwidth requirements
Our editors will review what you’ve submitted and determine whether to revise the article.
News •
The quality and quantity of television service are limited fundamentally by the rate at which it is feasible to transmit the picture information over the television channel. If, as is stated above, the televised image is dissected, within a few hundredths of a second, into approximately 200,000 pixels, then the electrical impulses corresponding to the pixels must pass through the channel at a rate of several million per second. Moreover, since the picture content may vary, from frame to frame, from simple close-up shots having little fine detail to comprehensive distant scenes in which the limiting detail of the system comes into play, the actual rate of transmitting the picture information varies considerably. The television channel must be capable, therefore, of handling information over a continuous band of frequencies several million cycles wide. This is testimony to the extraordinary comprehension of the human sense of sight. By comparison, the ear is satisfied by sound carried over a channel only 10,000 cycles wide.
In the United States, the television channel, occupying six megahertz in the radio spectrum, is 600 times as wide as the channel used by each standard amplitude modulation (AM) sound broadcasting station. In fact, one television station uses nearly six times as much spectrum space as all the commercial AM sound broadcasting channels combined. Since each television broadcast must occupy so much spectrum space, a limited number of channels is available in any given locality. Moreover, the quantity of service is in conflict with the quality of reproduction. If the detail of the television image is to be increased (other parameters of the transmission being unchanged), then the channel width must be increased proportionately, and this decreases the number of channels that can be accommodated in the spectrum. This fundamental conflict between quality of transmission and number of available channels dictates that the quality of reproduction shall just satisfy the typical viewer under normal viewing conditions. Any excess of performance beyond this ultimately will result in a restriction of program choice.
Compatible colour television
Compatible colour television represents electronic technology at its pinnacle of achievement, carefully balancing the needs of human perception with the need for technological efficiency. The transmission of colour images requires that extra information be added to the basic monochrome television signal, described above. At the same time, this more complex colour signal must be “compatible” with black-and-white television, so that all sets can pick up and display the same transmission. The design of compatible colour systems, accomplished in the 1950s, was truly a marvel of electrical engineering. The fact that the standards chosen at that time are still in use attests to how well they were designed.
The first compatible colour system was designed in 1950–51 by engineers at the Radio Corporation of America (RCA) and was accepted in 1952 by the National Television Systems Committee (NTSC) as the standard for broadcast television in the United States. (See the section The development of television systems: Colour television.) The essentials of the NTSC system have formed the basis of all other colour television systems. Two rivaling European systems, PAL (phase alternation line) and SECAM (système électronique couleur avec mémoire), are modifications of the NTSC system that have special application to European conditions. One or the other of these three systems has been adopted by all countries of the world. All are discussed in this section, with the American (NTSC) system being used to describe the basic principles of colour television.table
| Television systems of the world | |||||
|---|---|---|---|---|---|
| system (region or country) | number of lines per frame | number of pictures per second | maximum detail (picture elements per frame) | available picture bandwidth (MHz) | channel bandwidth (MHz) |
| NTSC (North America, South America, Japan) | 525 | 30 | 130,000 | 4 | 6 |
| PAL (United Kingdom, Germany) | 625 | 25 | 210,000 | 6 | 8 |
| SECAM (France, eastern Europe) | 625 | 25 | 210,000 | 6 | 8 |