The other major area in which air-cushion technology has proved itself useful is in moving loads over surfaces that would be impossible for wheeled or tracked vehicles. One of the first of these applications was an air-cushion amphibious military vehicle. Another was an air-cushion truck built in France. Air-cushion load lifters for specialized applications were already in regular use in the early 1970s. One of the first was a British heavy-load carrier, designed specifically for the transport of large electrical transformers over bridges that were not stressed for the weights involved when normal wheeled transport was used. The transformers, weighing up to 300 tons, must be transported by road from the factory to the often remote power-station site. The costs of strengthening bridges sufficiently to take the load are far higher than those of fitting a special skirt and air-blower system to a conventional truck.

Similar systems on a smaller scale have been developed for transport of many types of unusual loads over awkward ground. They find particular application in the Arctic regions, where roads are often lacking and where oil-drill rigs are being constructed or where surveying is being carried out. Air-cushion vehicles have shown a large economic advantage over helicopters.

On an even smaller scale, air-cushion pallets are used in many industries in the United States and Britain to carry heavy loads across factory floors or along production lines. Again the main benefit is the reducing of strain on floors and the ease of propulsion with reduced friction.

One unique form of air suspension may be employed in hospitals. The Hover-bed is a device on which a patient is supported with the minimum of body contact and surface pressure. The bed is being tested by the British Medical Research Council and is expected to be of particular use in cases in which the patient is burned over a large area of the body. Air support in such cases not only relieves pressure and pain but also provides a film of sterile air that actually helps to heal the wound.

Sporting Hovercraft

Still another application promises to be that of recreation. In the mid-1960s enthusiasts in many parts of the world began to build their own Hovercraft, powered by automotive engines and using homemade propellers, fans, and skirts.

By the 1970s Hover clubs existed in more than seven countries. The movement is probably most active in Britain, followed by the United States and Australia. Of the several hundred amateur-built craft, a few were capable of operating successfully over both land and water with more than one person aboard. Although power plants and other equipment are readily adaptable, the problem of providing sufficient lift was considerable. A craft capable of lifting 200 pounds (90 kilograms) needs a cushion area of 8 × 4 feet (2.4 × 1.2 metres). When weights of 1,000 pounds are involved, the area must be much greater. Another inhibiting factor in the sport’s growth is the restrictions in most countries on operating air-cushion craft in public areas.

The future

Air-cushion vehicles have not yet fulfilled their original promise. Conventional skirted craft have not yet been shown to be completely economical in commercial use, although in certain military applications they are almost ideal. The ram-wing craft described earlier shows promise for over-water routes.

One area of research in which manufacturers began concentrating in the 1970s is that of secondary suspension systems to iron out skirt undulations and possibly reduce spray ingestion.