A separate type of earthquake is associated with volcanic activity and is called a volcanic earthquake. Yet it is likely that even in such cases the disturbance is the result of a sudden slip of rock masses adjacent to the volcano and the consequent release of elastic strain energy. The stored energy, however, may in part be of hydrodynamic origin due to heat provided by magma moving in reservoirs beneath the volcano or to the release of gas under pressure.

There is a clear correspondence between the geographic distribution of volcanoes and major earthquakes, particularly in the Circum-Pacific Belt and along oceanic ridges. Volcanic vents, however, are generally several hundred kilometres from the epicentres of most major shallow earthquakes, and many earthquake sources occur nowhere near active volcanoes. Even in cases where an earthquake’s focus occurs directly below structures marked by volcanic vents, there is probably no immediate causal connection between the two activities; most likely both are the result of the same tectonic processes.

Reservoir induction

Of the various earthquake-causing activities cited above, the filling of large reservoirs is among the most important. More than 20 significant cases have been documented in which local seismicity has increased following the impounding of water behind high dams. Often, causality cannot be substantiated, because no data exists to allow comparison of earthquake occurrence before and after the reservoir was filled. Reservoir-induction effects are most marked for reservoirs exceeding 100 metres (330 feet) in depth and 1 cubic km (0.24 cubic mile) in volume. Three sites where such connections have very probably occurred are the Hoover Dam in the United States, the Aswan High Dam in Egypt, and the Kariba Dam on the border between Zimbabwe and Zambia. The most generally accepted explanation for earthquake occurrence in such cases assumes that rocks near the reservoir are already strained from regional tectonic forces to a point where nearby faults are almost ready to slip. Water in the reservoir adds a pressure perturbation that triggers the fault rupture. The pressure effect is perhaps enhanced by the fact that the rocks along the fault have lower strength because of increased water-pore pressure. These factors notwithstanding, the filling of most large reservoirs has not produced earthquakes large enough to be a hazard.

The specific seismic source mechanisms associated with reservoir induction have been established in a few cases. For the main shock at the Koyna Dam and Reservoir in India (1967), the evidence favours strike-slip faulting motion. At both the Kremasta Dam in Greece (1965) and the Kariba Dam in Zimbabwe-Zambia (1961), the generating mechanism was dip-slip on normal faults. By contrast, thrust mechanisms have been determined for sources of earthquakes at the lake behind Nurek Dam in Tajikistan. More than 1,800 earthquakes occurred during the first nine years after water was impounded in this 317-metre-deep reservoir in 1972, a rate amounting to four times the average number of shocks in the region prior to filling.

Britannica Quiz

36 Questions from Britannica’s Most Popular Science Quizzes

Seismology and nuclear explosions

In 1958 representatives from several countries, including the United States and the Soviet Union, met to discuss the technical basis for a nuclear test-ban treaty. Among the matters considered was the feasibility of developing effective means with which to detect underground nuclear explosions and to distinguish them seismically from earthquakes. After that conference, much special research was directed to seismology, leading to major advances in seismic signal detection and analysis.

Recent seismological work on treaty verification has involved using high-resolution seismographs in a worldwide network, estimating the yield of explosions, studying wave attenuation in the Earth, determining wave amplitude and frequency spectra discriminants, and applying seismic arrays. The findings of such research have shown that underground nuclear explosions, compared with natural earthquakes, usually generate seismic waves through the body of the Earth that are of much larger amplitude than the surface waves. This telltale difference along with other types of seismic evidence suggest that an international monitoring network of 270 seismographic stations could detect and locate all seismic events over the globe of magnitude 4 and above (corresponding to an explosive yield of about 100 tons of TNT).