Manufacturing optical lenses
Our editors will review what you’ve submitted and determine whether to revise the article.
- Key People:
- Giuseppe Campani
- John Henry Dallmeyer
- Alvan Graham Clark
- Related Topics:
- speed
- Fresnel lens
- aperture
- converging lens
- cylindrical lens
News •
In the manufacture of lenses, slabs of glass are cut with a glass saw or slitting disk; a piece of the desired type and shape is chipped to a rough, round blank, or the pieces may be heated to softness, rolled to a round shape, and pressed in a mold to the desired size and to approximately the desired curvature of the surfaces. The surfaces are then ground, or lapped, to the final form, using coarse emery, carborundum, or diamond as an abrasive. Lens surfaces are ground on an iron tool, either flat or suitably curved, using progressively finer grades of one of the abrasives mentioned above. In the grinding process, a rotating cup-shaped tool is mounted so that its axis of rotation intersects the axis of the lens at the centre of curvature of the desired spherical surface. The obliquity of the tool axis must be adjusted so that the rim of the tool cuts across the centre of the (concave) lens being generated. For convex lenses, the centre of the rotating tool face cuts the rim of the lens blank. As both tool and lens rotate about their respective axes, a spherical surface of the desired radius of curvature is generated on the lens.
Fine grinding, or smoothing, is done using carefully graded emery flour as an abrasive. A number of fine-ground lens blanks are then mounted with pitch on a block so that they can be polished together. The polishing tool is covered with a thin layer of pitch, wax, or even coarse cloth, and wet rouge or certain other mineral oxides are also used as polishing agents. The polishing of glass is a slow process, requiring lenses to be oscillated back and forth, sometimes for hours, against the rotating polisher. After both sides have been polished, the lens is ground around the edge to centre it and give it the correct diameter. If a compound objective is being made, several single lenses must be mounted together in a precise coaxial arrangement, and their thicknesses, separations, and centring must be kept very close to the prescribed values, or the aberration corrections laboriously determined by the lens designer will not be realized. The finished lens’s resolving power is then tested by using the lens to form an image of a point source or other suitable test object. Sophisticated variants of this basic testing procedure have been developed using photoelectric cells or interferometers to obtain greater measuring accuracy.